Neuer industrieller Stil mit besserem Grip
Die Pacific SF Fittings sind mit schraubenförmig gerändelten Rotatoren aus hochwertigem Messing geschmiedet und mit einer speziellen Oberflächenbehandlung versehen, die ein neues Aussehen mit fantastischer Ästhetik schafft und einen ergonomischeren Griff bei der Installation ermöglicht.
Bauen leicht gemacht mit ein wenig Hilfe
Bild als Referenz.
Drehen und Einstellen
Die Rotatoren sind in 2 Richtungen und um 360 Grad drehbar, was die Montage und Demontage erleichtert.
Wählen Sie, was am besten passt
Pacific SF Extender sind in Längen von 20 mm bis 30 mm in verschiedenen Ausführungen von G1/4-Gewinden erhältlich, von Außengewinde zu Außengewinde, von Innengewinde zu Außengewinde und von Innengewinde zu Innengewinde, so dass Sie eine große Auswahl haben, um Ihr Flüssigkeitskühlsystem effizienter zu gestalten.
Cautions
Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks:
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant; it may harm your loop and reduce performance.
- It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse, and dry them to ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup:
- It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing corrosion in the entire cooling system – copper, brass, nickel, aluminum, and steel.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushes the coolant into the loop.
- DO NOT let the pump run dry; turn off the power immediately if there is no liquid entering the pump.
- Fill the reservoir to the top to prevent air from entering the pump.
- If necessary, tilt the system slightly from side to side to bleed air out of the loop.
- Place some paper towels under fittings and joining points to check for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed air out of the loop.
- Before starting, flush your system correctly to prevent any coolant or unwanted particles from sticking to your tubes, radiators, and other cooling components.
- Note that coolant might fade over time.
| P/N | CL-W391-CU00WT-A |
|---|---|
| MATERIAL | Cu |
| Dimensions | 30mm Extender：∮22 x 40 (H) (mm) |
| Gewicht | 30mm Extender：77 g |
| Threads | G 1/4 |
| Notiz | Male to Male |
