|
||||
|
||||
|
||||
|
||||
|
||||
|
||||
|
||||
Thermaltake recommends the following steps to be taken after completing your water loop setup
|
Cautions
Thermaltake recommends the following steps to be taken
before using
the
Pacific series radiators and water blocks
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop
setup
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from going into the pump
- If necessary tilt the system slightly from side to side to bleed the air out of the loop.
- Place some paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
- Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
- Coolant might fade over time.
P/N | CL-W078-PL00BL-A |
---|---|
Dimensions | 81 (L) x 66.4 (W) x 139 (H) |
Connector | 3 Pin |
MATERIAL | POM+ PMMA |
Capacity | 120 ml |
Maximum head | 5.9 feet (1.8m) |
Maximum Flow Rate | 500 L/h |
Maximum pressure | 20 PSI |
Input Voltage | 12 V |
Parts | 1. Stopper *1 (G 1/4 ) 2. Bracket *2 |
Screw Thread | G 1/4 |
User Manual
- Dateiname
- Beschreibung
- Größe
- Version
- Release Date