Pacific M-Pro G1/4 PETG 12mm Fitting Kit- Chrome Pacific M-Pro G1/4 PETG 12mm Fitting Kit- Chrome Pacific M-Pro G1/4 PETG 12mm Fitting Kit- Chrome Thermaltake Workshop | M-Pro Fittings
Pacific M-Pro G1/4 PETG 12mm Fitting Kit- Chrome

Pacific M-Pro G1/4 PETG 12mm Fitting Kit- Chrome

Nicht auf Lager
P/N
CL-W170-CU00SL-B
86,90 € (included VAT)
Eine LCS-Kombi-Einheit umfasst ein G1/4-PETG-Rohr mit 90-Grad-Kompression 12 mm Außendurchmesser und eine M-Pro G1/4-PETG-Kompression 12 mm Außendurchmesser.
Thermaltake Pacific M-Pro PETG Fittings Montageanleitung

Step 1. Schieben Sie die Überwurfmutter über das Rohr
Step 2. Montieren Sie den O-Ring
Step 3. Montieren Sie die Dichtung.
Step 4. Montieren Sie den Befestigungssockel an Ihren Komponenten
Step 5. Die Überwurfmutter anziehen

Hinweis: Der O-Ring und die Dichtung mit einer Rille am Innendurchmesser müssen immer in Richtung der Oberseite der Überwurfmutter eingebaut werden.

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.
Mehr Informationen
P/N CL-W170-CU00SL-B
Dimensions 4.4(H) x 12.2(W) x 11.2(L)
Gewicht 0.39kg
Tube Dimensions OD : 12mm , ID : 10mm
Kit Contents Fittings
- Thermaltake Pacific G1/4 PETG Tube 90-Degree Dual Compression 12mm OD – Chrome x 2
- Thermaltake Pacific M-Pro G1/4 PETG 12mm OD Compression – Chrome x 6